DS200DMCBG1ABA GE DOS DUP 处理器板

DS200DMCBG1ABA  GE DOS DUP 处理器板 

DS200DMCBG1ABA 技术指标

产品描述

GE DOS DUP 处理器板 DS200DMCBG1ABA 包含 3 个 26 针连接器、1 个 40 针连接器和 19 个跳线。该板还有 2 个 LED。GE DOS DUP 处理器板 DS200DMCBG1ABA 包含 19 个跳线。有些跳线是在工厂设置的，不能更换。但是，可以移动某些跳线以满足站点的要求。原始板附带的信息描述了跳线以及它们如何改变板的功能。它还详细说明了哪些跳线不能移动。

更换旧板之前的佳做法是将更换DS200DMCBG1ABA板上的跳线设置为与旧板上的位置匹配。这样做使您能够将替换板配置为与旧板完全相同。另一个要求是服务商与旧板完全相同地连接更换板。您可以通过印在电路板上的连接器标识符和可以粘附在电缆上的写入标签来识别旧板上的连接器。然后，断开电缆并将它们重新连接到更换板上的相同连接器。
 

The GE DOS DUP processor board DS200DMCBG1ABA includes three 26 pin connectors, one 40 pin connector, and 19 jumper cables. The board also has 2 LEDs. The GE DOS DUP processor board DS200DMCBG1ABA contains 19 jumpers. Some jumpers are factory set and cannot be replaced. However, certain jumpers can be moved to meet the requirements of the site. The information accompanying the original board describes the jumpers and how they change the board's functionality. It also details which jumpers cannot be moved.
The best practice before replacing an old board is to set the jumper on the replacement DS200DMCBG1ABA board to match the position on the old board. This allows you to configure the replacement board to be identical to the old board. Another requirement is that the service provider connect the replacement board exactly the same as the old board. You can identify connectors on old boards by using connector identifiers printed on the circuit board and write labels that can be attached to the cable. Then, disconnect the cables and reconnect them to the same connectors on the replacement board.