DS200DMCBG1ABB GE DOS DUP 处理器板

DS200DMCBG1ABB  GE DOS DUP 处理器板

DS200DMCBG1ABB 技术指标

产品描述

GE DOS DUP 处理器板 DS200DMCBG1ABB 包含 3 个 26 针连接器、1 个 40 针连接器和 19 个跳线。该板还有 2 个 LED。GE DOS DUP 处理器板 DS200DMCBG1ABB 还配有一个 8 针连接器、一个 3 针连接器和一个 2 针连接器。由于多个连接器可能连接了电缆，因此在断开电缆与电路板的连接之前，记录电缆的连接位置非常重要。您会发现它加快了更换板的安装速度，并在重新启动驱动器时导致更少的错误。

断开电缆时，必须遵循防止损坏电缆的准则。始终握住电缆的连接器部分以断开电缆与电路板的连接。如果拉动电缆以断开连接，连接器上的压力可能会从连接器上拉出电线。这对于带状电缆尤其重要，因为构成带状电缆的多根细线。用一只手稳定电路板，另一只手握住电缆的连接器部分。然后，轻轻地将电缆从连接器中拉出。

The GE DOS DUP processor board DS200DMCBG1ABB includes three 26 pin connectors, one 40 pin connector, and 19 jumper cables. The board also has 2 LEDs. The GE DOS DUP processor board DS200DMCBG1ABB is also equipped with an 8-pin connector, a 3-pin connector, and a 2-pin connector. Since multiple connectors may have cables connected, it is important to record the cable connection location before disconnecting the cable from the circuit board. You will find that it accelerates the installation of replacement boards and causes fewer errors when restarting the drive.
When disconnecting cables, guidelines to prevent damage to the cables must be followed. Always hold the connector portion of the cable to disconnect the cable from the circuit board. If you pull the cable to disconnect it, the pressure on the connector may pull the wire out of the connector. This is particularly important for ribbon cables because of the multiple thin wires that make up the ribbon cable. Stabilize the circuit board with one hand and hold the connector portion of the cable with the other hand. Then, gently pull the cable out of the connector.