GE天才适配器板DS200ADCIH1A 有多个连接器

GE天才适配器板DS200ADCIH1A  有多个连接器

DS200ADCIH1A 技术指标

产品描述

GE Genius 适配器板 DS200ADCIH1A 具有 4 个跳线、1 个 20 针连接器和 3 个 40 针连接器。它还配备了两个可编程存储器 （PROM） 模块。GE Genius 适配器板 DS200ADCIH1A 上的 40 针连接器和 20 针连接器连接到传输控制信号的带状电缆。控制信号由电路板接收进行处理，一些控制信号传输到驱动器中的其他电路板和组件。计划更换时，请注意有关带状电缆的一些信息。带状电缆的处理方式必须避免损坏。由于带状电缆的结构，您在电缆上施加的任何压力都可能导致电线从连接器上脱落。从DS200ADCIH1A主板上拔下电缆时，仅握住连接器，然后将其轻轻从连接器上拉出。在从电路板上拔下电缆时，用空闲的手稳定电路板。

由于主DS200ADCIH1A板有多个连接器，因此记下连接器所插入的连接器标识符可能会有所帮助。使用少量胶带缠绕带有连接器信息的电缆。通过这种方式，重新插入电缆变得更加容易和快捷。它还有助于消除将电缆插入错误连接器的机会。

The GE Genius adapter board DS200ADCIH1A has four jumpers, one 20-pin connector, and three 40-pin connectors. It is also equipped with two programmable memory (PROM) modules. The 40 pin and 20 pin connectors on the GE Genius adapter board DS200ADCIH1A connect to ribbon cables that transmit control signals. The control signals are received and processed by the circuit board, and some control signals are transmitted to other circuit boards and components in the driver. When planning a replacement, please note some information about ribbon cables. Ribbon cables must be handled in a manner that avoids damage. Due to the structure of the ribbon cable, any pressure you apply to the cable can cause the wires to fall off the connector. When unplugging a cable from the DS200ADCIH1A motherboard, hold the connector only, and then gently pull it out of the connector. When unplugging the cable from the circuit board, use your free hand to stabilize the circuit board.

Since the main DS200ADCIH1A board has multiple connectors, it may be helpful to note the connector identifier inserted by the connector. Use a small amount of tape to wrap the cable with connector information. In this way, reinserting the cable becomes easier and faster. It also helps eliminate the opportunity to plug cables into the wrong connector.


 

品牌介绍：