DS200DMCBG1 GE DOS DUP 处理器板 DS200DMCBG1

GE DOS DUP 处理器板 DS200DMCBG1

DS200DMCBG1 技术指标

产品描述

GE DOS DUP 处理器板DS200DMCBG1包含三个 26 针连接器、一个 40 针连接器和 19 个跳线。 DS200DMCBG1板还有 2 个 LED。GE DOS DUP 处理器板还装有两个保险丝，服务商可以在必要时更换这两个保险丝。但是，执行保险丝更换必须遵循一些步骤。

如果您怀疑有问题，可以检查电路板。找到DS200DMCBG1并检查保险丝并检查保险丝中的元件是否熔断。在触摸任何组件、电缆或主板之前，请断开驱动器的所有电源。在继续操作之前，使用测试仪验证驱动器的电源是否已断开。另请注意，断开电源后，电源会在驱动器中驻留 20 秒。您可能需要卸下主板才能更换保险丝。使用螺丝刀卸下将电路板固定到位的四个螺钉和垫圈。将螺钉和垫圈放在一起并存放它们，因为您需要它们来重新安装电路板。在从电路板上卸下电缆之前，请注意电缆连接到电路板的位置。

将DS200DMCBG1放在静态保护袋的顶部，然后取下熔断的保险丝。您只能使用确切的替换保险丝。在更换保险丝之前，请参阅保险丝的额定值信息。如果保险丝的额定值不同，则可能会允许更多电流进入电路板并损坏组件。
 

The GE DOS DUP processor board DS200DMCBG1 contains three 26 pin connectors, a 40 pin connector, and 19 jumper cables. The DS200DMCBG1 board also has 2 LEDs. The GE DOS DUP processor board is also equipped with two fuses, which the service provider can replace if necessary. However, there are some steps that must be followed to perform a fuse replacement.

If you suspect a problem, you can check the circuit board. Locate the DS200DMCBG1 and check the fuse and check if the components in the fuse are blown. Before touching any components, cables, or motherboard, disconnect all power from the drive. Before continuing, use a tester to verify that the power to the drive has been disconnected. Please also note that after disconnecting the power supply, the power supply will remain in the drive for 20 seconds. You may need to remove the motherboard to replace the fuse. Use a screwdriver to remove the four screws and washers that secure the circuit board in place. Place the screws and washers together and store them as you need them to reinstall the circuit board. Before removing cables from the circuit board, pay attention to the location where the cables are connected to the circuit board.
Place the DS200DMCBG1 on the top of the static protection bag and remove the blown fuse. You can only use the exact replacement fuse. Before replacing a fuse, refer to the rating information for the fuse. If fuses are rated differently, they may allow more current to enter the circuit board and damage components.